[Oberon] Development boards
chris at cfbsoftware.com
Sun May 3 13:59:45 CEST 2020
> -----Original Message-----
> From: Skulski, Wojciech [mailto:skulski at pas.rochester.edu]
> Sent: Sunday, 3 May 2020 12:30 PM
> To: chris at cfbsoftware.com; ETH Oberon and related systems
> Subject: RE: [Oberon] Development boards (was: Interfacing with Foreign
> > In the meantime my understanding is that there is sufficient information
> available for the Pepino to enable anybody to get a board manufactured.
> Presumably a batch would need to be ordered to be feasible.
> Design files do not seem to be available.
Yes - you are right. Now when I look more closely under the heading 'Board
design files' I can see there are only copyrighted schematic and upper /
lower board layouts provided. Gerber files (or their equivalent) are not
> I bet that Magnus would run a
> batch production if there is enough demand.
Indeed. That would be the way to go. He was very co-operative when I asked
him about the possibility of organising that. However, that was more than a
year ago so he'd need to be asked again by anybody who was thinking of going
down that route. What I didn't find out was what constitutes 'enough
More information about the Oberon