AW: AW: [Oberon] New A2: How to stop boot.

[Stauber Sven Philipp]

AHCI definitely won't work, but when SATA mode is set to RAID, ATADetect=raid should help.

>Nevertheless it then says: No Devices found.
If ATADetect=raid doesn't cause some devices to be listed here, try ATADetect=raid+other.

Good luck!
Sven

-----Ursprüngliche Nachricht-----
Von: oberon-bounces at lists.inf.ethz.ch [mailto:oberon-bounces at lists.inf.ethz.ch] Im Auftrag von Edgar Schwarz
Gesendet: Mittwoch, 3. März 2010 12:40
An: oberon
Betreff: Re: AW: [Oberon] New A2: How to stop boot.

So,
no luck yet Sven :-(


With TraceMode=1 I see something.
ATADetect=legacy is finding a controller with an IDE0 and IDE2.
Nevertheless it then says: No Devices found.
So I went to the BIOS: Phoenix 11/12/08
- SATA mode = RAID. The other alternative is AHCI which is especially 
mentioned in the troubleshooting guide as being bad.!
So what should I do now?
I have a Fujitsu/Siemens Amilo Xi 3650 with 1920x1080.

Regards, Edgar

Stauber Sven Philipp schrieb:
> Dear Edgar,
>
> Either enable ScrollLock or hold down the shift key to interrupt the Oberon Boot Loader. MaxProcs=1 most likely won't help (the bug that made this configuration string necessary was fixed quite some time ago).
>
> For some detailed startup troubleshooting guide, see http://www.ocp.inf.ethz.ch/wiki/Documentation/Installation#toc11. 
>
> Best,
> Sven
>
>   
--
Oberon at lists.inf.ethz.ch mailing list for ETH Oberon and related systems
https://lists.inf.ethz.ch/mailman/listinfo/oberon