[Oberon] PO2013 - Real time measurement

[Tomas Kral]

Hi Paul,

Thank you, while digesting your reply. This quick caught my
attention.

> Having done a lot of nRF24L01 programming, you should also be very
> well placed to connect a PIC SPI port directly to the nRF24L01 module,
> programmed in PICL, to create a remote self-contained "sensor node",

How about extending board's SPI socket, into a sort of cable bus,
devices put on a ribbon cable. Then question remains, how to address the
nodes using distinct CS signal for each, also not sure what length of
ribbon cable could SPI handle. It is meant just for sensor logic in
immediate vicinity of FPGA board. The analog signals will be carried by
longer cables to actual sensors / probes.

-- 
Tomas Kral <thomas.kral at email.cz>