[Oberon] PO2013 - SD Image Tool

[Tomas Kral]

On Fri, 22 May 2020 10:04:43 -0700
Magnus Karlsson <magnus at saanlima.com> wrote:

> They don't go to FTDI chip, they are ready signals from the
> transmitter and receiver block that software can read.

Hi Hagnus,

Thanks for reading this and bearing with me. I had asked, but somehow
forgot all about it. 

I send receive files over USB, looking at its signals
(peering inside the USB connector, 4 wires, incl VCC and GND).

RS232 is RxD, TxD, and flow control signals (CTS/RTS or DSR), GND.
Minimum of 5 wires/signals.

This is failing me, unless FTDI does some magic. Can we do h/w flow
control over USB?

I possibly mistaken rdyTx, rdyRx for CTS, RTS, respectively, right?

as rdyTx, rdyRx are not terminals on the Pepino board?

-- 
Tomas Kral <thomas.kral at email.cz>