[Oberon] detecting USB storage on a Belkin F5U220

[shark at gulfnet.sd64.bc.ca]

If a Kingston storage is plugged into sockets 0 or 2, 
counting from the system board edge, of a Belkin F5U220, 
it is detected with Partitions.Show ~.

If the Kingston storage is plugged into sockets 1 or 3
it is not detected with Partitions.Show ~.

The booklet with the card specifies both OHCI and EHCI 
compliance.  No mention of two types of connector.  
Usb.Info in the old Usb.Tool fails.

Any ideas?  Would it be that sockets 1 and 3 are strictly 
EHCI?  Is there an Aos replacement for Usb.Info?  
PCITools.Scan output is appended.

Thanks,         ... Peter E.

======================================================
  [video and ethernet info. omitted]
   
Bus 0, device 11, function 0: class/rev 0C031043, vendor/device 10330035, status/cmd 02100016
	Class: Serial bus controller, Sub-class: USB Controller, ProgIntfc: OHCI
	Vendor: NEC Corporation, Device: USB
		IRQ10, INTA
		4KB 32-bit memory at E4800000 - E4800FFF

Bus 0, device 11, function 1: class/rev 0C031043, vendor/device 10330035, status/cmd 02100016
	Class: Serial bus controller, Sub-class: USB Controller, ProgIntfc: OHCI
	Vendor: NEC Corporation, Device: USB
		IRQ12, INTB
		4KB 32-bit memory at E4000000 - E4000FFF

Bus 0, device 11, function 2: class/rev 0C032004, vendor/device 103300E0, status/cmd 02100016
	Class: Serial bus controller, Sub-class: USB Controller, ProgIntfc: EHCI
	Vendor: NEC Corporation, Device: USB 2.0
		IRQ9, INTC
		256B 32-bit memory at E3800000 - E38000FF

8 devices found

Desktops.OpenDoc  http://carnot.pathology.ubc.ca/